Examples of 'screw located' in a sentence
Meaning of "screw located"
screw located: An indication or description of the positioning of a screw, possibly used in a technical or mechanical context
How to use "screw located" in a sentence
Basic
Advanced
screw located
Undo the fixing screw located on the longitudinal.
Remove the handle of your mixer . To do this, unscrew the small screw located underneath.
Adjust the screw located outside the thermostat.
Unplug motor cord from receptacle and remove screw located next to receptacle.
Remove the screw located at the bottom of the front cover.
Use a thin blade screw driver to turn the screw located in the brass shaft.
Remove the screw located in the lower right corner of the cover.
Remove switch housing assembly by loosening set screw located immediately below housing base.
Remove the screw located in the lower righthand corner of the cover.
Remove the keypad backplate by loosening the screw located at the base of the unit.
Remove the cap screw located between the bladder and reservoir handle.
Fully open the chuck and unscrew the fastening screw located at its centre caution.
The screw located in the hole beneath the cap adjusts the position of the lever.
Loosen the middel screw located in the bottom.
Loosen screw located in the center of hex knob approximately 3 turns.
See also
Remove the Allen screw located in the.
Remove the screw located on the lower position of the rear guard Figure 7, Figure 8.
Remove the control cover, unscrewing the screw located in the bottom part.
Remove 6mm screw located on the underside of assembly.
To adjust the outer flame, turn the bypass valve screw located at the valve stem.
Open the bleed screw located at the highest point.
Before using the scale, remove the shipping protection screw located underneath the scale.
Use the locking screw located on the PCM knob to secure it.
Lean cleaner handle back . Remove the screw located on the headlight lens.
Fully unfasten the screw located in the Handle Socket to insert the assembled handle picture 3.
Use a phillips screwdriver to remove the nozzle cover screw located behind the caster Diagram 2.
Remove the 5.6mm screw located on the upper right corner of the motherboard.
Using a phillips screwdriver, remove the screw located on the centre of the light cover.
Loosen 6mm screw located on the underside of assembly Fig . 47.
Proceed as follows, - Loosen screw located on lower side.
Remove the handle screw located on the back of the vacuum Fig . 1.
Unscrew grille securing screw located at the top of the grille.
Remove green ground screw located beneath the terminal block.
Remove the long screw located above the rear panel.
Remove the belt tension screw located at the front of the shredder.
Remove the recessed set screw located on the top face of the enclosure.
Loosen the support retaining screw located in the top front of the machines base.
Tripod mounting screw located on rear, not shown.
Using a phillips screwdriver, remove the screw located on the center side of the light cover.
Adjust the bucket holders using the thumb screw located underneath each holder, if necessary.
Note, Remove the screw located in the vacuum.
Using a Phillips-head screwdriver, remove the screw located in the lower right-hand corner of the cover.
You'll also be interested in:
Examples of using Screw
Show more
Tighten the screw through the clips
Screw the two sections of pole together
Remove the screw on the rear coupler
Examples of using Located
Show more
The battery is located underneath a cover behind
Etta and her team have been located
They have located that second meteor
