Examples of 'screw length' in a sentence
Meaning of "screw length"
screw length: The measurement of the length of a screw from the tip to the head, often specified in hardware and construction contexts for appropriate use and installation
How to use "screw length" in a sentence
Basic
Advanced
screw length
Screw length not set correctly.
Setting for desired screw length.
The screw length is read at the end of its head.
Adjust nosepiece to correct screw length.
Always select a screw length which is shorter than the.
Use this chart to select the correct screw length.
The screw length correlative to the thickness of wall mount holder.
Refer to operators manual for proper adjustment of screw length.
Set the screw length on this unit by sliding the guide block.
Pick appropriate screw length.
The screw length varies with the thickness of the steel plate.
The magazine attachment must be adjusted to the screw length being used.
Check the screw length and diameter at the scale of the measuring module.
Check the adjustable nosepiece for proper screw length setting.
Always select a screw length which is shorter than the thickness of the furniture door.
See also
Screw holes were drilled and tapped and screw length estimated.
Screw length could vary depending on cupboard material thickness and gap between range and cupboards.
Care should be taken to use the proper screw length when mounting.
G Screw length needed depends on the wall mount used.
The taper of the screw is essentially conical along the screw length.
The film then grows along the screw length and eventually fills the channel.
Do not make the starter holes deeper than half the screw length.
Tool is in reverse Screw length is improperly set.
The preoperative plan can be also used to accurately determine proper screw length.
A scale on the depth gauge shows the ideal screw length for the measured drill hole.
Align marks on the adjustable nosepiece with edge of feed housing for proper screw length.
Bit is worn Screw length improperly set.
Number indicated on the label Screw length.
Screw length and screw-in depth adjustment.
Number indicated on the plate Screw length range.
A suitable screw length was selected, and the screw was placed.
NOTE, Do not make the holes deeper than half of the screw length.
At that moment, only the screw length needs to be adapted.
Note - Screw length needed depends on the wall mount used.
There are 3 positive-lock screw length settings.
The appropriate screw length and size can be determined in two different ways:.
With the core diameter of the thread to approx . 2 / 3 of the screw length.
One can customize the screw length by cutting off the ratcheting portion, as desired.
M4 Tapping Screws Not included, screw length depends on vehicle.
NOTE The correct screw length setting is very important for trouble-free magazine operation.
Setting for desired screw length Fig . 3.
Often screw length is referenced to its diameter as I, D ratio.
Note, Use the right screw length that fit the backposts size.
Screw length has been designed to accommodate 3/8 " and above cabinet depth.
A preferred screw length is 44xD.
Pedicle perforation, screw length and spondylolisthesis were assessed on post-operative CT-Scan.
Extruder C has a screw length of 20 times the diameter and a compression ratio of 4.
You'll also be interested in:
Examples of using Screw
Show more
Tighten the screw through the clips
Screw the two sections of pole together
Remove the screw on the rear coupler
Examples of using Length
Show more
Tubing length and elevation difference limits
Cut wire liner at the right length
Only the length of the journey differs
