Examples of 'screw plug' in a sentence
Meaning of "screw plug"
screw plug - a mechanical device used to close off a hole or opening, typically with a threaded design that allows for easy attachment and removal. This term is commonly used in engineering and construction contexts
How to use "screw plug" in a sentence
Basic
Advanced
screw plug
Screw plug for oil drain valve.
Screw the inlet screw plug back in.
Clean screw plug and tank after refuelling.
Remove the allen hey and screw plug b back on.
A screw plug for intensive sessions.
Once emptying has been carried out the screw plug is again fitted.
Loosen screw plug inside pressure tap located on underside of valve.
Unscrew oil refill reservoir and screw in oil screw plug No.
Clean around the screw plug and the tank after refuelling.
Use the Allen key supplied to open the screw plug.
Screw plug on unused connection a c d f eg Install provided insulation.
Use the Allen key supplied to tighten the screw plug.
Screw plug with nut, for distribution manifold outlets.
To do so, remove the screw plug on the oil filler port.
In addition, inferior quality corner valves are often equipped with a plastic screw plug.
See also
Wipe the screw plug and tank with an adsorbent af ter refuelling!
In addition to their many benefits, electric screw plug heaters are environmentally friendly.
Remove screw plug at base of handle with a very small flat-blade screwdriver.
Intake integrated in jerrycan for safe, space-saving deposit of spigot and screw plug.
Opening sealed with screw plug for screwing in spigots and corner valves wide thread 22 mm.
N If no grease can be seen on the inside of the screw plug 1.
Dowel pin / screw plug / allen key bolts.
After fitting of the strainer tighten the screw plug 20b.
Remove the screw plug ( 9 ) from the required hydraulic connection 7.
This hole is threaded and is sealed off by a leakproof screw plug 24.
Unscrew the screw plug ( 20b ) from the cold water connection piece and take out the strainer 20a.
The top of the filter is sealed against the screw plug 12.
N Insert the screw plug ( 1 ) and tighten it down firmly.
The spring and plunger are retained in place by a retaining screw plug 15.
Screw in the second screw plug ( 9 ) and tighten to a tightening torque of 12 Nm.
Model with drain valve 3 Remove the screw plug 7.
Unscrew the brass screw plug 1 at the sawing gap ( Fig . 3 ) of the work table.
The container neck 11 internally mounts a unit comprising a pouring spout 2, a screw plug 10 and a strainer element 3.
Screw plug for test hole ( M5 or M6 ) on the drive-side end shield must be removed.
