Examples of 'sprocket cover' in a sentence
Meaning of "sprocket cover"
a protective covering or shield that is used to enclose and safeguard a sprocket, which is a toothed wheel or gear used to transmit rotational motion. It is commonly used in machinery or mechanical systems to prevent debris, dust, or other elements from interfering with the sprocket's functioning
How to use "sprocket cover" in a sentence
Basic
Advanced
sprocket cover
Loosen the sprocket cover fastening nuts.
Turn it counterclockwise a little to loosen sprocket cover lightly.
To fix the sprocket cover on the engine housing.
Removing the chain sprocket cover.
Install the sprocket cover over the bar stud.
The drive chain sprocket is covered with a sprocket cover.
The bar and the sprocket cover are fitted.
The sprocket cover is secure after three audible clicks are heard.
Never start the pole pruner with the sprocket cover loose.
Place the sprocket cover so that the hooks fit.
Turn the lever counterclockwise until the sprocket cover comes off.
Remove sprocket cover and take out both and chain.
Chips and saw dust will accumulate inside of the sprocket cover.
Reinstall the sprocket cover and saw chain on the tool.
Keep holding the guide bar lightly and tighten the sprocket cover.
See also
Position the sprocket cover over the sprocket as shown and.
Finally hand tight the chain tension bolt and the sprocket cover.
Replace the sprocket cover and tighten the nut gently.
Remove any chips and sawdust from the tool after removing the sprocket cover.
Fasten the sprocket cover using the guide bar bolt.
Moving direction of the chain Marked under the sprocket cover.
Remove the sprocket cover and saw chain from the tool.
N Unscrew the nut and remove the chain sprocket cover.
Align the tabs on the sprocket cover with the slots in the mounting plate.
Clean guide bar, sprocket and sprocket cover.
The captive nut on the sprocket cover allows for quick changing of the chain.
To adjust saw chain tension, loosen allen head screw on sprocket cover.
Tighten the sprocket cover nut securely while lifting the tip of the guide bar.
Unscrew the bar retaining knob and remove drive sprocket cover . the drive sprocket cover.
Arrows on the sprocket cover and tensioning knob must align before the cover is replaced.
Keep holding the guide bar lightly, tighten the sprocket cover after adjusting the chain tension.
Replace the sprocket cover on top and tighten gently with the knob w / nut.
Using finger-pressure only, install the sprocket cover nut.
N Remove the sprocket cover with captive nuts.
The drive sprocket of the output shaft is covered with a sprocket cover 36.
Securely attach sprocket cover BEFORE operating.
Once in place, hold the bar still, replace sprocket cover F.
Re-attach the sprocket cover on the motor housing.
Remove sprocket cover 6 as described in Installing the Guide Bar and Saw Chain section.
After each use, remove the sprocket cover and clean the area beneath.
Front sprocket cover Minarelli AM6 plastic black.
Counterclockwise a little to loosen sprocket cover lightly . Fig . 6.
Position sprocket cover ( 2 ) over sprocket or pulley.
New muffler, altered gear ratios, straight-pull spokes, new sprocket cover and larger side-stand foot.
Step 8 of 15, Replace the sprocket cover on the engine unit and tighten both nuts hand-tight.
The bar and the sprocket cover are fitted correctly ;.
Sprocket 24 months Open the sprocket cover and apply grease . It is recommended once a month.
You'll also be interested in:
Examples of using Cover
Show more
Remove the battery cover by sliding it downward
Cover and keep warm up to one hour
Unscrew the bulb cover by turning anticlockwise
Examples of using Sprocket
Show more
A worn sprocket damages a new saw chain
Remove pivot screw on drive sprocket side
Have the sprocket replaced in this case
