Examples of 'switch selects' in a sentence
Meaning of "switch selects"
switch selects - This phrase is commonly used in the context of technology or electronics to indicate the action of choosing different options or settings using a switch
How to use "switch selects" in a sentence
Basic
Advanced
switch selects
This switch selects one of two characteristics.
When listening to FM stations this switch selects stereo or monaural.
This switch selects the signal to be recorded.
To accommodate a wide range of input amplitudes, a switch selects calibrated sensitivity of the vertical deflection.
This switch selects the frequency response of the subwoofer.
Stages For all versions, a 5-way DIP switch selects the stage required for each stage.
This switch selects the signal source of the input module.
Setting Up . 2g CHANNEL, This rotary switch selects the desired carrier fre.
This switch selects the signal source for the stereo module.
CUE MIX, This three position switch selects what output is sent to the headphones.
The switch selects the input from which the signal is routed to the single output.
SELECT - This switch selects the effects group.
This switch selects anyone of the forty Citizens Band channels desired.
The X-OVER MODE switch selects the required operation mode.
This switch selects the source for the Monitor outputs or Headphones.
See also
Operating Level Switch - This switch selects between a -10 dBV and +4 dBu nominal operating level.
Switch selects between microphonelevel, line-level, or microphone-level with phantom power.
This rotary switch selects the desired carrier frequency.
Switch selects between full operation of the amplifier ( “ on ” position ) and Standby mode “ off ” position.
For this, the matrix switch selects an available device from the pool after switching.
This rotary switch selects the desired carrier frequency or its alternative frequencies.
The Output Mic / Line switch selects either microphone - or line-level output signals.
A bitstream switch selects between the outputs of these delays and the output of the recoder.
The CH3/4 X-OVER MODE switch selects the required operation mode of this channelpair.
This switch selects the input method of the signals to be amplified by amplifiers A and B.
The MODE switch selects stereo or mono operation.
MODE switch selects between smooth class A or highly-responsive class AB operation with tighter bottom end.
The pickup selector switch selects between neck pickup, both pickups and bridge pickup tones.
The MODE switch selects between three basic characteristics with CLEAN providing maximum headroom.
The “ Mode ” switch selects the operating mode.
This switch selects the channel Lead or Clean.
The X-OVER switch selects the required operation mode of the amplifier.
ASSIGN - This switch selects the audio source on which the effects will be applied.
This switch selects the signal that is output to the ST2/MONI OUT jack.
This switch selects channel 9 or 19 according to the configuration.
This switch selects between stereo 3-way operation and mono 5-way operation.
The slide switch selects between two different pickup circuits, the " lead " and " rhythm " circuits.
You'll also be interested in:
Examples of using Selects
Show more
Selects between dates or proposes other availability
Pushing this button selects an operation mode
It selects the air flow rate setting
Examples of using Switch
Show more
The floating switch is blocking in automatic operation
Opera never survived the switch to electric
Set the switch to the correct position
