Examples of 't-peel' in a sentence
Meaning of "t-peel"
t-peel (noun): A kitchen tool designed to efficiently peel fruits and vegetables in a T shape
How to use "t-peel" in a sentence
Basic
Advanced
t-peel
The adhesive transfer was determined visually after the T-Peel test.
Some increase in T-peel value is seen for all samples.
T-Peel values were measured according to the procedure described previously.
The bonded sheets were then machined to fabricate T-peel specimens.
The T-peel values are reported in grams per linear inch.
The failure mode is noted as described in the T-peel test.
The results were verified by performing T-peel testing on remaining test coupons.
The T-peel seal strength is commonly specified according to individual manufacturer requirements.
The tests were run at the same time as the cotton T-peel test.
The bonding conditions on T-Peel specimens wer identical to these shown in Example 7.
This is typically measured by percent transfer of the cohesive when peeling in a T-peel configuration.
The bonding conditions for the T-Peel specimens were identical to those shown in Example 7.
The practical adhesion is represented by the force of resistance observed in the T-peel test.
The T-Peel Adhesion test values indicated in the Examples are the average of 5 independent determinations.
The heat sealed área was subjected to the T-peel test described in Reference Example 1.
See also
The T-Peel adhesion results are reported below in Table 4.
All of compositions 6 - 8 had surprisingly high T-Peel results and a better mixed adhesive / cohesive failure mode.
Figure 5A shows a schematic setup of a t-peel test.
Sample dimensions and T-peel test procedures used are shown in Fed.
A T-peel test on a 2.54 cm strip was used to quantify the actual peel values obtained.
The bonding conditions for T-Peel specimens were identical to those in Example 7.
T-Peel and shear bond test results are also given where available . Table 3,.
The trends observed for the initial T-peel values are continued at 24 hours.
Cotton T-peel test The cotton material was cut into strips 2 inches by 5 inches.
The exposure times and intensities, and the T-peel test results are shown in Table 6.
Measurement of T-peel strength The specimen was cut to have a width of 15 mm.
Compositions 11 and 12 yielded substantial improvements in T-Peel strength compared to conventional composition A.
The T-peel bond is measured immediately on an Instron tensometer with 305 mm / minute speed.
FIG . 5A shows a schematic setup of a t-peel test.
Composition 9 had the highest T-Peel result of all compositions and a mixed adhesive / cohesive failure mode.
The samples were then tested for SAFT, and / or PAFT and T-peel.
The bonding conditions for T-Peel specimens were identical to conditions used in Examples 1 and 2.
The T-Peel Value is reported in Newtons per decimeter ( N / dm ).
Listed in Table 2 are T-peel data comparing syndiotactic homopolymer to syndiotactic C3/C6 copolymer.
The T-peel results are shown in Table 6.
