Examples of 'transfer switch' in a sentence
Meaning of "transfer switch"
transfer switch - This phrase refers to an electrical device that allows for the transfer of power source between two or more electrical circuits. It is commonly used in situations where a backup power source needs to be activated in case of a power outage or failure
How to use "transfer switch" in a sentence
Basic
Advanced
transfer switch
Access to transfer switch must not be obstructed.
Poor wiring connections or defective transfer switch.
Automatic transfer switch does not transfer to generator.
Take a look at the transfer switch here.
Automatic transfer switch does not transfer to utility.
I just gotta flip the transfer switch.
Hold transfer switch against the mounting surface.
This permits the manual transfer switch.
This transfer switch requires installation before use.
Transfer device for automatic transfer switch.
Transfer switch with battery charger.
We have tracked it down to the transfer switch.
The transfer switch operating lever should be down.
Turn the service disconnect to the transfer switch on.
So it will have a transfer switch embedded into the mainframe.
See also
Reinstall the dead front to the transfer switch.
A transfer switch is usually installed near your circuit panel.
Anchors and screws to mount transfer switch to wall.
Level the transfer switch and mark the mounting holes.
I will activate the transfer switch.
The transfer switch is designed to be maintenance free under normal usage.
Turn on the utility power to the transfer switch.
Failure to properly ground transfer switch can result in electrocution.
Turn off the utility power to the transfer switch.
Wait five minutes for transfer switch to retransfer to utility power.
Terminal strip on control module in transfer switch has.
Do not mount the transfer switch in the generator or lp gas compartment.
This is accomplished via a transfer switch.
Transfer switch off.
Do you have a transfer switch.
See inside transfer switch enclosure for proper torque values.
Turn the service disconnect to the transfer switch off.
A quick transfer switch is not always sensitive nor is it always desired.
Install the generator as close as possible to the transfer switch.
An automatic transfer switch is a device used to reroute power in special circumstances.
Generator power voltage is now supplied to the transfer switch.
Manual operation of the transfer switch is required if electronic operation should fail.
Maintenance will consist mainly of keeping the transfer switch clean.
Use a manual transfer switch when connecting directly to a building electrical system.
If it can be removed then no modifications to the transfer switch installation are needed.
The transfer switch will connect to the utility after five minutes.
Keep the area around the transfer switch clean and uncluttered.
A transfer switch is an electrical switch that switches a load between two sources.
Connection to any other transfer switch will void your generator warranty.
A transfer switch is a very important component of any emergency or standby power system.
Recent calls to check if the transfer switch has been installed have gone unanswered.
A transfer switch is the easiest way to power your home during an outage.
If the contacts on the automatic transfer switch remain open no action is taken.
Essential loads are grouped together and wired into the transfer switch.
Only the transfer switch and the charger will work normally.
You'll also be interested in:
Examples of using Switch
Show more
The floating switch is blocking in automatic operation
Opera never survived the switch to electric
Set the switch to the correct position
Examples of using Transfer
Show more
Transfer to care within social welfare services
I need to confirm a transfer into our account
Transfer of organs of the child for profit
