Examples of 'turn screw' in a sentence
Meaning of "turn screw"
turn screw - This phrase could refer to the act of tightening or loosening a screw using a screwdriver, or it can be used figuratively to describe increasing pressure or making a situation more difficult
How to use "turn screw" in a sentence
Basic
Advanced
turn screw
Turn screw to apply pressure to shaft end.
The powder blend is fed into a turn screw melt extruder.
Continue to turn screw clockwise until doors are level.
The valve apparatus provides for a flow gap adjustment by way of a manual turn screw arrangement.
Turn screw with hex key tool until tight.
Spool retainer hard to turn Screw threads are dirty or damaged.
Turn screw G to adjust the hydraulic rebound damper.
To lower cabinet or door, turn screw counterclockwise.
Carefully turn screw so that stop in end position is not damaged.
To raise cabinet or door, turn screw clockwise.
Turn screw inwards to depress tow valve pin H.
While holding valve stem stationary, turn screw in.
Turn screw housing 9 anticlockwise and remove it.
Correct assembly of clamping wedge, turn screw once into the clamping wedge with left-handed thread.
Turn screw counter clockwise, position up.
See also
Increase the hook thread tension Turn screw 1 clockwise.
To remove blade, turn screw holding blade counterclockwise.
If patterns are distorted as shown in illustration ( a ), turn screw in direction of symbol.
Turn screw clockwise, Idling speed increases.
To lower front, turn screw counterclock.
Turn screw a ( on the bobbin case ) for tension.
To raise front, turn screw clockwise.
Turn screw clockwise in 1/4 turn increments to increase the idle speed.
If patterns are distorted as illustration ( d ), turn screw in direction of symbol.
Turn screw ( 2 ) with hexagonal wrench and observe the behaviour of the ribbon.
If patterns are distorted as illustration ( b ), turn screw in direction of symbol.
Turn screw counter-clockwise, Idling speed decreases.
For light pressure turn screw 4 in an antl-clockwIse direction.
If patterns are distorted as shown in illustration ( b ), turn screw in direction of symbol.
Turn screw out, anticlockwise, and additional 1 turn.
Decrease the hook thread tension Turn screw 1 counter-clockwise.
Turn screw 2 to position the combustion head 3, referring to.
If winding not even, make adjustments, Turn screw colockwise, position down.
To “ lock ” turn screw one quarter turn counter-clockwise.
Tighten screws so parts are mated together, then turn screw only 1/8th of a turn more.
Turn screw ( 7 ) counterclockwise to undo the main tube clamp.
Universal camera adaptor Standard 1/4 Turn Screw allows for mounting most video and still cameras.
Turn screw ( D ) clock-wise until it stops but do not tighten.
Looped Wire, Turn screw to loosen.
Turn screw 4 ( B ) until the notch identified is aligned with the front surface 5 ( B ) of the flange.
If clamping force is too low, N Carefully turn screw ( 2 ) clockwise a.
Using wrench ( C ) supplied, turn screw ( E ) until knife just touches straight edge.
