Examples of 'turn the ignition switch' in a sentence
Meaning of "turn the ignition switch"
turn the ignition switch: to activate the electrical system in a vehicle by turning a key or pressing a button that starts the engine
How to use "turn the ignition switch" in a sentence
Basic
Advanced
turn the ignition switch
Turn the ignition switch to the unlocked OFF position.
Insert the ignition key and turn the ignition switch to the ON position.
Turn the ignition switch OFF and remove the second key.
The headlight and taillights will come on whenever you turn the ignition switch ON.
Be sure to turn the ignition switch OFF when replacing the bulb.
After installation of this unit, turn the ignition switch to ON.
Then turn the ignition switch to the ON position without starting the engine.
When strange or incorrect messages ap - pear on the display 1 Turn the ignition switch OFF.
Turn the ignition switch to the LOCK position and remove the second key.
Before working on the device, turn the ignition switch is in the off position lamps.
Turn the ignition switch to the ACC position to prevent the steering from locking up.
Before starting, insert the key, turn the ignition switch ON and confirm the following.
Turn the ignition switch to the LOCK position while depressing the brake pedal.
Check the antenna connection . - Turn the ignition switch OFF and back to ON again.
Turn the ignition switch to the ON position and make sure all doors are closed.
See also
Before removing the detachable device, turn the ignition switch off ACC OFF.
Turn the ignition switch to the ACC position while pushing the start knob in.
To end the adjustment, press the MODE button or turn the ignition switch OFF.
Turn the ignition switch to the ON position.
Insert the second valid key and turn the ignition switch ON within 15 seconds.
Turn the ignition switch OFF and.
With the Disarm / Valet switch turned on, repeatedly turn the ignition switch on and off 3 times.
Turn the ignition switch to the ACC or ON position.
Check the speaker connection . - Turn the ignition switch OFF and back.
Turn the ignition switch to OFF.
Insert the ignition key, and turn the ignition switch to the ON / RUN position.
Turn the ignition switch to the ON position Do not.
While pressing the OPEN / CLOSE button, turn the ignition switch ON or to ACC.
Turn the ignition switch to the ON position Do not start the engine.
To stop the engine in an emergency, turn the ignition switch [ 1 ] to the OFF position.
Turn the ignition switch to the ON or ACC position and press the time button.
With a helmet headset connected to the JMCB-2003K turn the ignition switch to the ON position.
Turn the ignition switch OFF and back to ACC or ON.
With a helmet headset connected to the JMCB-2003 turn the ignition switch to the ON position.
Turn the ignition switch OFF and then to ACC or ON.
After disarming, turn the ignition switch to the ON position.
Turn the ignition switch off, and then start the car as you normally would.
Start the vehicle or turn the ignition switch to the " accessory " position.
Turn the ignition switch to the LOCK position, and remove the key.
To stop the engine, turn the ignition switch till the position OFF « » see fig . 3.
Turn the ignition switch to the ON position, but do not start the engine.
Subsequently, turn the ignition switch to on ( ACC ON ) again.
Turn the ignition switch to the ON position and complete the following procedure within 5 seconds.
Momentarily turn the ignition switch to the START position ; the engine should not crank.
Turn the ignition switch to the OFF position and buckle the driver 's seat belt.
When you turn the ignition switch to ON after installation, SET UP.
Turn the ignition switch OFF before checking or replacing fuses to prevent accidental short-circuiting.
Then, turn the ignition switch to the LOCK position and remove the first key.
Turn the ignition switch off, and plug the electrical connector back to the TPS.
Turn the ignition switch OFF, then turn it ON.
You'll also be interested in:
Examples of using Turn
Show more
Persuade him to turn over a new leaf
Now turn around and meet him
The unit does not turn on when installed
Examples of using Switch
Show more
The floating switch is blocking in automatic operation
Opera never survived the switch to electric
Set the switch to the correct position
Examples of using Ignition
Show more
Vi potential ignition sources including electrical equipment
Do not expose the fluid to an ignition source
Do not touch ignition key while running
