Examples of 'wing screw' in a sentence
Meaning of "wing screw"
wing screw - A type of screw with a head that is designed to be easily tightened or loosened by hand, without the need for a screwdriver or other tool. Wing screws are commonly used in applications where quick adjustments or frequent removal is needed
How to use "wing screw" in a sentence
Basic
Advanced
wing screw
Loosen the wing screw by turning it counterclockwise.
Replace and tighten the wing screw assembly.
Wing screw for adjusting the plate.
Place the sensor bracket with wing screw on top of the opening.
Wing screw for inclining the plate.
Fix the camera in the required position using the wing screw.
Wing screw for depth stop.
Fix the sensor in the correct height position using the wing screw.
Remove the wing screw from the grass deflector.
Lock the balance plate by turning the red wing screw clockwise and tighten it.
Loosen the wing screw on the front and rear base.
N Line up the handlebar and secure it in position with the wing screw.
Loose the wing screw and insert the rip.
Depth stop Open the wing screw.
Insert the wing screw through the mounting bracket and into the grass deflector.
See also
N Only tighten the wing screw moderately.
N Turn the wing screw counterclockwise until the handle support can be moved.
Accessories plate Wing screw Wing nuts.
Wing Screw Secures the lower part of the drive tube stub shaft.
N Fold the grip of the wing screw down so that it is flush.
Wing Screw Locks loop handle in selected position.
Expander tool on the drive unit and tighten with wing screw 2.
N Rotate the wing screw counterclockwise and tighten it only moderately.
Then tighten the wing screw 1 again.
Wing screw for adjusting the depth gauge 9.
Re-tighten the wing screw afterwards.
Setting clamp 5, set the required cutting depth on the scale 19 and retighten the wing screw.
N Rotate the wing screw clockwise until it becomes difficult to turn.
Secure the filter cover by turning the wing screw ( 51 ) clockwise.
Loosen the Wing Screw on the coupler of the.
Adjust the depth stop ( 6 ) to the required routing depth and tighten the wing screw 7.
Turn the wing screw until it is hand-tight.
Secure the parallel guide with the wing screw ( 19 ) to the machine housing.
Turn the wing screw 1 anti-clockwise and swivel the additional handle 7 into the desired position.
N Raise the grip of the wing screw ( 8 ) to the upright position.
N Loosen the wing screw ( 3 ) just enough for the handlebar to be moved.
Fasten the square pin ( N ) with a wing screw ( S4 ) on the opposite side of the fire bowl.
Loosen the wing screw While doing so, hold the drill rig firmly!
Then undo the wing screw on the right-hand side of the fan head.
N Release the wing screw ( 3 ) - the clamps are loose once the wing screw has been released.
J Turn the wing screw 9 anti - clockwise and mount the additional handle 10 in the vertical position.
Self-drilling wing screw with drill point, type S WW.
N Pull out the wing screw - the washer ( 6 ) remains on the wing screw.
N Loosen the wing screw ( 8 ) and unscrew it until the handlebar ( 2 ) can be turned clockwise.
