Examples of 'adjustment screw' in a sentence
Meaning of "adjustment screw"
An adjustment screw is a small screw or bolt that is used to make fine-tuned adjustments or changes to the position, tension, or calibration of a mechanical device or system. It allows for precise and incremental changes to be made, often in order to optimize performance, functionality, or alignment
How to use "adjustment screw" in a sentence
Basic
Advanced
adjustment screw
Fine adjustment screw for stretch stitches.
Main nozzle needle mix adjustment screw.
Fan adjustment screw not seating properly.
Do not overtighten the door adjustment screw.
Turn roller adjustment screw to lower door.
If the rotary hook lubrication adjustment screw e is.
Roller adjustment screw should be turned until.
Loosen the pan angle adjustment screw.
Tighten the adjustment screw until it bottoms.
Sensitivity can be set on the adjustment screw.
Turn roller adjustment screw to raise or lower.
Loosen the presser foot adjustment screw w.
Turn the adjustment screw of the thermostat.
Tighten the presser foot adjustment screw w.
Spreader adjustment screw not seating properly.
See also
Make and type of idling adjustment screw.
Turn roller adjustment screw to raise door.
Loosen hex nut securing adjustment screw.
Adjustment screw for movement detection.
Turn front roller adjustment screw clockwise to.
Adjustment screw for belt run.
Tighten the riving knife adjustment screw v.
Turn the adjustment screw to the correct setting.
Loosen the tilt angle adjustment screw.
The height adjustment screw may require periodic.
Tighten air shutter adjustment screw.
Adjustment screw for canopy rotation.
Turn the down limit adjustment screw counterclockwise.
Adjustment screw for depth of cut.
Saw chain oil adjustment screw.
Turn adjustment screw clockwise to increase pump pressure.
Turn the lubrication adjustment screw while referring.
Adjust the fan vertically by vertical adjustment screw.
Reset idle mix adjustment screw to factory settings.
Adjusting the idle speed mix adjustment screw.
Turn rear roller adjustment screw clockwise to raise.
Start by adjusting the main mixture adjustment screw.
Replacing the adjustment screw bellows.
Typically such means comprise a second adjustment screw.
The fine adjustment screw is not adjusted properly.
Fully tighten the adjustment screw in.
Turn the adjustment screw r to adjust the walking foot.
Locate the valve adjustment screw.
Turn the adjustment screw until the flame reaches.
Spring bonnet with adjustment screw.
Tighten the adjustment screw locknut when satisfactory.
The adjustment means may include an adjustment screw.
The mixture adjustment screw is the brass slotted.
Use a screwdriver to loosen the air shutter adjustment screw.
Access pilot adjustment screw through.
You'll also be interested in:
Examples of using Adjustment
Show more
Adjustment for accrued income from investments
The single flow adjustment knob allows
Adjustment for other accruals and liabilities
Examples of using Screw
Show more
Tighten the screw through the clips
Screw the two sections of pole together
Remove the screw on the rear coupler
