Examples of 'clamp washer' in a sentence
Meaning of "clamp washer"
clamp washer - A clamp washer is a type of washer designed to provide a secure fastening for a clamp or similar device. It is typically used to distribute the clamping pressure evenly and prevent damage to the surface being clamped
How to use "clamp washer" in a sentence
Basic
Advanced
clamp washer
Remove outer clamp washer and saw blade.
Be sure wheel goes over pilot diameter of inner clamp washer.
Install the outer clamp washer and blade screw.
Start threading on spindle nut which will self align outer clamp washer.
Lift tongue of clamp washer up and out of slot under size bar.
Remove the old blade carefully by easing it off the inner clamp washer.
Make sure inner clamp washer is in place and ears are engaged with spindle flats.
Make sure that the saw blade is piloted on the outer clamp washer hub QQ.
Engage the clamp washer threads on the tool spindle and thread assembly clockwise, com.
Remove the blade screw, outer clamp washer and blade.
Place inner clamp washer ( G ) on saw spindle with the large flat surface facing out toward.
When installing the dado stack, do not include the inner clamp washer.
Install the clamp washer ( C ) with the raised center away from the cutter blade A.
Remove the blade clamping screw ( k ) and outer clamp washer o.
Place outer clamp washer ( o ) on saw spindle with the beveled edge facing out.
See also
Remove the blade clamping screw ( j ) and outer clamp washer n.
Place inner clamp washer ( O ) on saw spindle with the large fl at.
Remove the nut ( OO ) and outer clamp washer PP.
Place outer clamp washer ( H ) on saw spindle.
Remove the blade clamping screw ( F ) and outer clamp washer ( N ) only.
Ensure large surface of outer clamp washer is toward blade, as shown in Fig . 9.
Remove the blade clamping screw ( F ) and outer clamp washer ( O ) only.
Be sure outer clamp washer ( R ) engages flats on spindle.
Remove the keyless blade clamp ( H ) and outer clamp washer ( P ) only.
The inner clamp washer ( I ) may be left on the spindle.
Remove the blade clamping screw ( H ) and outer clamp washer ( P ) only.
Place inner clamp washer ( O ) on saw spindle with the large flat.
Push the hub of the clamp washer ( I ) through the center of the sanding ( M ) and phenolic.
Replace the outer clamp washer ( 53 ) which will require rotating to find.
You'll also be interested in:
Examples of using Clamp
Show more
Do not subject the clamp to running water
You clamp the top of your throat
Then tighten the clamp screw securely
Examples of using Washer
Show more
Insert washer and thread nut to screw
The following is a guide to using your washer
This pressure washer is designed for cold
