Examples of 'duct connector' in a sentence
Meaning of "duct connector"
A duct connector is a device or component used to connect sections of ductwork together. It ensures a secure and sealed connection, allowing air or other substances to flow smoothly through the ducts without any leaks or interruptions
How to use "duct connector" in a sentence
Basic
Advanced
duct connector
Blower and duct connector in horizontal discharge.
Air deflector with upper duct connector.
Blower and duct connector in vertical discharge.
Repeat this for each duct connector.
The duct connector is shipped inside the deflector.
Attach existing ducting to duct connector.
Add a duct connector together with adjustable louvres.
Measure and install steel ductwork to hood duct connector.
Hold air deflector with duct connector against the ceiling.
Install duct up through support frames onto the duct connector.
Press duct connector into the plenum until it snaps into place.
Press the damper into the duct connector on the hood.
Pull existing ducting through housing discharge opening and tape ducting to duct connector.
Install the discharge collar into the duct connector of the range hood.
Cable duct connector Covering cap for front cover.
See also
Cut the duct piece to size and slip onto the bottom of the duct connector.
Screws used to attach duct to Duct Connector may prevent damper from opening.
Actual Size for attaching the damper duct connector.
A flexible duct connector of non-combustible material.
Press discharge collar / damper into blower duct connector.
Snap damper / duct connector onto housing.
Check that the back draft damper in the fan 's duct connector.
Connect duct section to duct connector and duct rough-in.
The duct connector has a counter-balanced damper flap.
Attach an adequate length of 6 ” round steel ducting to the range hood duct connector.
Connect the duct to the damper / duct connector and seal with duct tape.
Attach 6 ” to 5 ” reducers to the blower discharge and the plenum duct connector.
The duct will cover / overlap the duct connector and the exhaust outlet.
Mount the duct connector ( provided ) before installing the cooker hood fig . 2.
Attach aluminum flexible duct to the damper / duct connector with a tie wrap.
Attach the damper / duct connector to the hood with ( 4 ) M4 x 8mm pan head sheet metal screws.
Remove the damper flaps from the damper / duct connector and discard flaps.
Snap the 6 ” diameter duct connector into place on the plenum.
If it does, remove flap on hood damper / duct connector.
Install the 5 ” diameter duct connector to plenum.
Attach 6 ” aluminum duct to the hood duct connector.
The flap will be “ open ” approx . 1 ” when duct connector is attached to housing.
Attach 6 " metal vent duct to the hood duct connector.
Check that the back draft damper in the fan 's Duct Connector pivots freely.
Connect 4-inch round ductwork to damper / duct connector.
Attach expandable duct to the plenum through the duct connector Fig.18.
You'll also be interested in:
Examples of using Connector
Show more
Only the appropriate connector must be used
Purple connector for black whip antenna
Plug the charger connector into the
Examples of using Duct
Show more
Change duct size gradually to minimize turbulence
Durable rotomolded duct rings and housing
Duct supports are recommended to support weight of cabinet
