Examples of 'hose diameter' in a sentence
Meaning of "hose diameter"
hose diameter ~ the width of a hose or pipe measured from one end to the other. It is an important measurement, especially in plumbing, gardening, and firefighting contexts
How to use "hose diameter" in a sentence
Basic
Advanced
hose diameter
Check recommend hose diameter and length.
Hose diameter is not right for switch position.
Set correct switch position for hose diameter.
A suitable hose diameter ranges preferably from a few to ten millimeters.
Nomogram to determine the hose diameter ND.
Suction hose diameter should be at least as large as the pump intake opening.
This minimum permitted inner diameter gives an outer hose diameter of around 22 mm.
The hose diameter and the setting for the suction hose diameter must be the same.
Ensure that the airflow regulator 5 is in the position of the hose diameter used.
Hose diameter too small Use correct hose diameter.
Such a mechanism may involve a coil spring 28 applied to the interior or exterior hose diameter.
Depending on the hose diameter used, the hose adapter must be shortened accordingly.
This cab heater has two air intakes for flexible hose diameter 75 mm.
The hose diameter does not correspond to the switch ( 12 ) position.
Our standard hose cooling units allow a maximum hose diameter of 50 mm. Other sizes on request.
See also
The pipe length is 6 m before the pump and 18 m after the pump, with a 3 inch hose diameter.
Distribution hose diameter (mm).
Increase hose diameter and provideadequate water supply 20 PSI, 6 GPM.
Color is available for Green or Black . Water hose Diameter, 5x8 mm.
Increase hose diameter and provide adequate water supply 20 PSI, 6 GPM.
You'll also be interested in:
Examples of using Hose
Show more
Store chemical hose so it is protected from damage
Hose nozzle air suction regulator is open
Disconnect hose from used water tank
Examples of using Diameter
Show more
A change in wire diameter results in changed parameters
Diameter of and pressure in the fire mains
The incoming hole diameter on auxiliary terminal
