Examples of 'lag screws' in a sentence
Meaning of "lag screws"
lag screws - type of fastener with a hex head and external coarse threads
How to use "lag screws" in a sentence
Basic
Advanced
lag screws
Lag screws must not be hammer driven.
Securely tighten the lag screws.
Lag screws must be installed in these area.
Masking tape or thumbtacks lag screws.
Lag screws may be human chorionic gonadotrophin.
Securely tighten all lag screws and bolts.
Insert lag screws into both end holes.
Securely tighten all lag screws.
Lag screws in the nature of orthopaedic surgical instruments.
Install the bottom two lag screws first.
Lag screws in the nature of orthopaedic surgical implants.
Washers of rubber for the protection of lag screws.
Lag screws and construction screws.
And then the lag screws.
Insert lag screws into both bottom corner holes.
See also
Washers of vulcanised fibre for the protection of lag screws.
I would prefer bolts to lag screws in a situation like this.
Disassemble the lock box by previously removing the lag screws.
You must use lag screws to mount the header bracket.
You will need to drill a couple of holes on the window and insert the lag screws.
Lag screws are traditionally specified for many structural loads in wood construction.
The fixture can be mounted with three lag screws and washers which are provided.
The track MUST be RIGIDLY fastened to structural support on ceiling using lag screws.
Commercial bolts or lag screws are used for the test metal substrates.
Alternative fasteners include, but are not limited to dynamic lag screws.
Mount the arm and bracket using four lag screws and washers provided.
Greater diameter lag screws can be used but using the same number as permitted above.
Attach brackets to wall with lag screws Not provided.
Insert lag screws into the 4 corner holes.
O Acoustic lag screws.
Next, secure mounting plate to the wall by tightening toggle bolt assemblies or lag screws.
Place the fixture on these two lag screws and install the top lag screw.
Tighten the top lag screw first, then tighten the remaining lag screws.
Implants, normally lag screws and reconstruction plates are preferred implants.
Preferably, the femoral neck screws utilized are 6.5 mm diameter titanium lag screws.
On wooden walls, drive hi test wood lag screws into the studs of the wall.
Lag screws 3/8 in . diameter may be used in place of common nails as follows.
Secure the SPU using the lag screws ( 2 ) provided with the SPU unit.
Number and weigh ( WM1 ) a series of bolts or lag screws.
At least 8 lag screws are recommended.
Face Mount Square Track Face mount to track girt with 5/16 ” lag screws or bolts.
Screw in the lag screws so that there is about 3/8 " of space under the head.
Place the 3/8 " lag screws through the air compressor feet, washers and into the anchors.
Place the 3/8 ” lag screws through the air compressor feet, vibration pads and into the anchors.
Screw the 4 lag screws provided see Fig . 4, do not tighten completely.
You'll also be interested in:
Examples of using Lag
Show more
Then the lag is gonna be an easy fix
I think that must be the jet lag
Lag time response on drillpipe pressure gauge
Examples of using Screws
Show more
The screws are provided in the literature pack
Fully tighten screws with hex wrench
Screws are visible on the burner control panel
