Examples of 'lever must' in a sentence
Meaning of "lever must"
This phrase is incomplete and lacks clarity. Please provide additional context or clarify the intended meaning so that I can provide an appropriate definition
How to use "lever must" in a sentence
Basic
Advanced
lever must
The lever must then be retightened properly.
The governor control lever must be fully open.
The lever must be fixed in this position.
The LCD screen will briefly show a message advising that the buttonhole lever must be lowered.
Propel lever must be squeezed to activate brush.
When leaving the vehicle the selector lever must always be set to P.
The lever must be open while dipping.
For this, the valve lever must be repositioned.
The lever must snap audibly into place.
Stock foot pegs and brake lever must be re-used.
The selector lever must be unlocked in case of emergency.
As soon as blade enters the material, retracting lever must be released.
The safety lever must latch audibly.
Between one dispensing and the next, the tap lever must be reset.
The clutch lever must always be free.
See also
With pulling back the feeder knob, the push lever must move smoothly.
This lever must snap audibly into place.
During measurements, the gear lever must be in the neutral position.
The lever must be against the handlebar to start the engine.
Note that the hand lever must not be mounted again!
The lever must be pressed and pushed to release Very good.
At the start of running, the parking lever must be disengaged intentionally.
The valve lever must not be locked while operating the machine.
With this construction, the adjuster lever must be of a large size.
The locking lever must latch into the desired position.
During operation, the steam control lever must not be wedged open.
The bevel lock lever must be attached before operating the tool.
When using the auxiliary valve, the lift control lever must remain in neutral.
The servo control lever must fit tight on the servo shaft.
To lay out the Walschaerts gear, the proportions of the combination lever must be chosen.
Blade depth lever must be tight and secure before making cut.
To do this, disengage the carriage metal lever must engage with the plastic lever.
The locking lever must be locked into place for these to work properly.
For coffee grinder-dosers, the doser lever must always be.
The disengagement lever must never be between the outer and inner positions.
You have closed the lid properly ( the lever must be locked properly ) ;.
This lever must be set to ON to start the engine.
Checking, - The clamping force of the clamping lever must securely.
After adjustment the locking lever must audibly latch into the desired position.
The lever must hold firmly its ( locked parked ) setting with out easily being released.
The clearance of the clutch lever must be approximately 10 mm figure 4.
The lever must be held in position to keep the engine running . N.
Upper threading, The needle and the take-up lever must be raised.
Throwout Lever must be pushed open on straight threads.
For an automatic transmission, the gearshift lever must be in the “ DRIVE ” position.
The fuel valve lever must be in the ON position for the engine to run.
WARNING - In order for the chain to turn, the accelerator lever must be pressed!
The PTO lever must be placed in the disengaged position to start the tractor.
When cutting metal the Cutting Action Selection Lever must be set to the ‘ 0 ' position.
The shift lever must be put in neutral before being shifted to R.
