Examples of 'loosen the screws' in a sentence
Meaning of "loosen the screws"
loosen the screws - This phrase is a directive to make screws less tight or to undo them, often in the context of repairs or construction
How to use "loosen the screws" in a sentence
Basic
Advanced
loosen the screws
Loosen the screws and remove the.
Use this to try to loosen the screws.
Loosen the screws under the seat.
Use a small phillips screwdriver to loosen the screws.
Loosen the screws of the battery holder.
Remove the blunt extension by loosen the screws.
Loosen the screws three to four turns.
Unscrew the top and loosen the screws on rod ends.
Loosen the screws on the rear panel.
Be sure to prevent these from falling as you loosen the screws.
Loosen the screws by turning them counterclockwise.
Unscrew the top and loosen the screws at the rod ends.
Loosen the screws in the fastener head.
Pull out to remove the frame and then loosen the screws.
Do not loosen the screws beyond necessity.
See also
Again and again and again till we loosen the screws Do it again.
Loosen the screws for this purpose.
Make sure that you only loosen the screws instead of completely unscrewing them.
Loosen the screws on the lamp unit.
Lift the tilt stand and loosen the screws with a suitable Phillips screwdriver.
Loosen the screws on both sides of the projector.
For making adjustments, loosen the screws carefully.
Loosen the screws on the top of each clamp.
If the tub is distorted, loosen the screws a little.
Loosen the screws do the fi ller panels slide.
If holders are seated incorrectly, loosen the screws retighten.
Loosen the screws fi xing the alignment springs on.
To change the batteries, loosen the screws on the bottom.
Loosen the screws to remove the side brackets.
To install the templet guide, loosen the screws on the tool.
Loosen the screws of the cover in the lid.
If blade or blade plate are seated incorrectly, loosen the screws and retighten.
Loosen the screws securing the lamp cover.
If distortion of the sample occurs, loosen the screws and tighten again.
Loosen the screws with a screwdriver.
When connecting cables, loosen the screws and remove the terminal cover.
Loosen the screws of the right cleaning cover.
Use a crosshead screwdriver to loosen the screws on the drop-in iris slot cover.
Loosen the screws securing the light cover.
Using a small fl athead screwdriver, loosen the screws on the terminal block, located on.
Loosen the screws and nuts.
To adjust the kerf plate, loosen the screws holding the plate in place.
Loosen the screws on each terminal.
With the supplied tool, loosen the screws holding the unit from the.
Loosen the screws holding the bottom hinge.
To adjust the kerf plates, loosen the screws holding the kerf plates in place.
Loosen the screws in the battery compartment door.
From the back of the saw, loosen the screws holding the mounting bracket.
Loosen the screws on the tracks and remove the.
After mounting the anemometer, loosen the screws on the battery door with a small screwdriver and.
You'll also be interested in:
Examples of using Screws
Show more
The screws are provided in the literature pack
Fully tighten screws with hex wrench
Screws are visible on the burner control panel
Examples of using Loosen
Show more
Loosen the screw at the rod extensions
Use a screwdriver to loosen the air shutter
Loosen the lower pin with a key
