Examples of 'phillips screw' in a sentence
Meaning of "phillips screw"
phillips screw: A Phillips screw is a type of screw used for fastening materials, with a cross-shaped slot in its head designed to be used with a Phillips screwdriver
Show more definitions
- A screw with a Phillips head.
How to use "phillips screw" in a sentence
Basic
Advanced
phillips screw
Phillips screw driver is required for installation.
Remove the spacer screw with a phillips screw.
Please use a phillips screw driver for installation.
As illustrated the pivot point is a phillips screw head.
Remove Phillips screw from top of door.
Remove battery cover by turning phillips screw counterclockwise.
On some models you need to screw the hinge box cover using a phillips screw.
Install Phillips screw and tighten until snug.
The story of the invention of the phillips screw.
Remove Phillips screw from each side of rail system.
As illustrated the screw head is a phillips screw head.
Remove the Phillips screw from the bottom of the micro.
Proceed to tighten each bolt with a phillips screw driver.
Use a Phillips screw driver to loosen the two captive screws.
Remove side cover screws using medium phillips screw driver.
See also
Remove Phillips screw from each side of drawer rail assembly.
Tighten the screws using a Phillips screw.
Transfer one Phillips screw opposite center hinge area to the hole.
Remove top hinge cover by removing Phillips screw.
Remove Phillips screw from each side of rail system select models.
All it takes are four steps and a Phillips screw driver.
Remove the Phillips screw revealed beneath the round cover plate.
Replace the top hinge cover using the existing Phillips screw.
Tighten the Phillips screw in the air shutter and remove the LP conversion jig.
Remove light shield by removing the Phillips screw on the top of the shield.
Reinstall the cartridge retaining bracket and secure it with the Phillips screw.
Countersunk Phillips screw.
Using a Phillips screw driver, tighten the screws until the shield is firmly in place.
Hold each nut in place while tightening each bolt securely with a Phillips screw driver.
And a small phillips screw on each side,.
Phillips is a registered trademark of Phillips Screw Company.
Insert the Phillips screw through the back of each of the 4.
Secure the module board using the supplied Phillips screw see red arrow in figure.
Using a hand Phillips screw driver or your power drill, install the screw loosely.
Installation and Connections Prepare a Phillips screw driver beforehand.
Remove the Phillips screw from the bottom of themicrophone base, then remove the retainer.
Tools necessary, rubber mallet and phillips screw driver are not included.
Remove the Phillips screw from the cartridge retaining bracket, then remove the bracket.
Securely re-tighten the Phillips screw that secures.
Remove the Phillips screw from the bottom of the microphone base, then remove the retainer.
Remove the 4 screws as shown with a Phillips screw driver.
Using the same Phillips screw driver, remove the single screw securing the battery strap.
Refit the drive belt cover, using the Phillips screw.
Use a Phillips screwdriver to slightly tighten the Phillips screw 7.
All preventive maintenance tasks can be performed with a Phillips screw driver!
Use a small Phillips screw driver to adjust the LIGHT control see Figure 4.
Remove 4 screws with Phillips screw driver.
Use a small Phillips screw driver to adjust the TIME control see Figure 4.
Each pickup roller installs with a single Phillips screw seen in Figure 1.
Phillips screw driver, straight slot screw driver, adjustable wrench, step ladder, and wire cutters.
You'll also be interested in:
Examples of using Phillips
Show more
Phillips would have had me stuck in a lab
Screwdrivers phillips head and flat head
Phillips screw driver is required for installation
Examples of using Screw
Show more
Tighten the screw through the clips
Screw the two sections of pole together
Remove the screw on the rear coupler
