Examples of 'spool cover' in a sentence
Meaning of "spool cover"
A protective cover or casing for a spool, which is used to hold and wind various materials, such as wire or thread
How to use "spool cover" in a sentence
Basic
Advanced
spool cover
Carefully clean the spool cover and housing.
Spool cover from the housing.
Firmly place the thread spool in the spool cover.
Fit the spool cover back in the spool mount.
Keep the tabs depressed and remove the spool cover.
Press both locking tabs of spool cover simultaneously and remove.
Remove any dirt and grass from the spool cover.
Remover the spool cover and remove the empty spool.
Align the arrows on the bump knob with the spool cover eyelets.
Press the thread spool cover down until in snaps into place.
Take the new spool and push it onto the boss in the spool cover.
Remove any grass from spool cover when changing line or spool.
Automatic line feed does not work Keep the tabs depressed and remove the spool cover.
Always ensure that the spool cover is secure before and after use.
Bring the Nylon cord through the Nylon cord eyehole in the spool cover.
See also
Align the tabs on the spool cover with the holes on the outer.
Take the empty spool 17 out from the spool cover.
Align the tabs on the spool cover with the holes in the housing.
Fit a new, full spool as described in ‘ Assembling the spool cover.
Align the tabs on the spool cover with the cut outs in the.
The line should protrude approx . 11 cm from the spool cover.
The cutouts on the thread spool cover need to be aligned with the locking tabs j.
A spool cover can be attached to side wall 108b with bolts passing through mounting holes 116.
U Align the tabs on the spool cover with the cut outs in the housing.
Put the spool cover together with thread spool on the spring 19.
Press both locking tabs of spool cover simultaneously and remove Fig . W1.
Remove the spool cover and spool f rom spool housing See Figure 23.
Figure 29 - Replacing spool cover onto spool housing.
Remove the spool cover and the spool, as previously described.
Press in both spool cover lock buttons, then remove the spool cover.
Replace spool cover onto spool housing and snap into place . See Figure 29.
Remove the spool cover from the housing 12.
Turn the spool cover 14 counter-clockwise and remove.
Place the spool cover ( 6b ) on the bottom part of the spool I.
You'll also be interested in:
Examples of using Cover
Show more
Remove the battery cover by sliding it downward
Cover and keep warm up to one hour
Unscrew the bulb cover by turning anticlockwise
Examples of using Spool
Show more
Put a spool of thread on the spool pin
Check to see if the spool is properly wound
Move spool holder to remove both spools
