Examples of 'test voltage' in a sentence
Meaning of "test voltage"
Test voltage refers to the electrical voltage applied during the testing of a device or circuit. It is used to assess the performance, functionality, or safety of the system under examination. Test voltage is usually different from the normal operating voltage to simulate a variety of scenarios and ensure proper functioning
How to use "test voltage" in a sentence
Basic
Advanced
test voltage
The test voltage to the secondary side.
The tests shall be made at test voltage.
Test voltage for signalling devices.
Points at which test voltage is applied.
Measurements have to be carried out at relevant test voltage.
Largest test voltage used to verify the meters.
Constant current source maintains applied test voltage.
The test voltage shall be stated in the test report.
Remember remote conductors may be charged to the test voltage.
End test voltage.
Small modules can be tested with lower test voltage.
Normal test voltage.
Power consumption measurements shall be carried out at relevant test voltage.
They determine the test voltage that is to be applied to the line.
Pending on the model chosen regardless of the test voltage selected.
See also
The antenna sends a test voltage to the fi xture to diagnose the failure.
Do not connect the voltage terminals of the analyser to the test voltage.
This is a test voltage which is set without regard for load compensation.
Filament lamps shall first be aged at their test voltage for approximately one hour.
The test voltage in particular partly depends on the properties of the electrodes used.
Iii the phase displacement between test voltage and test current to produce maximum torque.
The measurement circuits contain filters which reject all but the test voltage frequency.
Tests shall be made at test voltage as specified in the relevant lamp data sheet.
The output of the rectifier has a test voltage Um.
Here the test voltage is applied between either terminal s or v and the ground clamp.
Press the TEST button to activate the test voltage.
The test meter applies a test voltage between the working electrode and the reference electrode.
The test terminal 6 may receive or give a test voltage.
Applying a constant test voltage gives rise to a variation of the resulting current I in the battery.
Group of electricians using an OHM meter to test voltage in an industrial power center.
The test voltage Utest for electrical equipment and wiring for high voltage circuits shall be.
When using the test voltage waveform of FIG.
Test voltage Nominal operational current.
The time of application of the test voltage shall be 1 min.
The first test voltage has both an AC voltage component and a DC voltage component.
The time of application of the test voltage is fixed at 1 min.
U Test voltage at which the measurement shall be carried out V.
With high power protection due to 4kV test voltage.
The superimposed alternating test voltage component can be applied for a time interval indicated by Tcap.
Breakdown occurs in an electric arc, leading to a collapse of the test voltage.
Test Load Applied test voltage multiplied by the applied test current.
Since good insulation is resistive, an increase in test voltage will lead to an in -.
Test voltage Volts.
The secondary windings are designed to withstand a test voltage of 3 kV against each other.
If the test voltage is below the minimum, replace.
Immediately after ignition of the arc, the test voltage is switched off automatically.
The applied test voltage preferably corresponds to a cut-off transistor.
Have been tested to withstand voltages well above the highest test voltage gen -.
If we apply a test voltage across a piece of insulation, then by measuring the.
Upon the completion of the test time interval tT, the test voltage is removed.
You'll also be interested in:
Examples of using Test
Show more
Mechanical tensile test prehoistable navigation lights
A test with tripping is compulsory on installation startup
Before the test we had art class
Examples of using Voltage
Show more
Voltage drop due to use of extension cable
Information on the voltage is on the rating plate
Voltage measure switch for phase voltage
