Examples of 'thickness of the membrane' in a sentence
Meaning of "thickness of the membrane"
thickness of the membrane: the distance between the two surfaces of a membrane, often discussed in scientific or technical contexts
How to use "thickness of the membrane" in a sentence
Basic
Advanced
thickness of the membrane
It is usually inserted in the thickness of the membrane seal.
The thickness of the membrane is dependent on the sealing pressure.
These parameters generally depend upon the thickness of the membrane.
The required wall thickness of the membrane is primarily determined by the need for robustness.
The flux was found to be strongly dependent on the thickness of the membrane.
Local modifications in the thickness of the membrane may also have an effect.
The average value of four measurements represents the thickness of the membrane.
The mass and thickness of the membrane can vary depending upon the desired application.
The preferred concentrations will depend on the thickness of the membrane desired.
Thickness The thickness of the membrane is determined with a caliper.
The heterogeneous material has two transport paths through the thickness of the membrane.
As described above, the thickness of the membrane is small.
When the thickness of the membrane material is too thick, the water permeability decreases.
The two areas excavated in the general thickness of the membrane are of different dimensions.
However, using rigid ceramic membranes involves a double constraint the thickness of the membrane.
See also
According to another feature, the thickness of the membrane seal can be smaller than 1 mm.
The thickness of the membrane in a membrane / electrode assembly can vary with the type of membrane.
Membrane thickness Defines the thickness of the membrane.
In addition, the thickness of the membrane will condition its sensitivity to enzymatic lysis.
These two notches are made through the entire thickness of the membrane 6.
The length, width, and thickness of the membrane were then measured with a caliper.
The dope flow rate is chosen to provide a desired thickness of the membrane layer 14.
Typically, the thickness of the membrane will diminish from the backing plate to the aperture.
The standard currently specifies that the dry film thickness of the membrane must be 60 mils.
A thickness of the membrane is preferably in the range of from 10 µm to 1 mm.
The only exception is the thickness of the membrane 2 '.
The thickness of the membrane is 50 um and it has an external diameter of 8 mm.
The epitaxy layer 44 enables the thickness of the membrane to be monitored.
The total thickness of the membrane is, in principle, less than or equal to 1 mm.
The epitaxied layer 34 is used to control the thickness of the membrane.
Therefore, the thickness of the membrane is preferably 5 µm or more.
Homogeneous temperature is also obtained thus over the whole thickness of the membrane ( 30 ).
Alternatively, the thickness of the membrane seal 1 is smaller than 5 mm.
The crosslinking times vary from 5 to 10 seconds, depending on the thickness of the membrane.
The thickness of the membrane in this second area is on the order of 0.2 mm.
Uniform temperature is also obtained right through the thickness of the membrane ( 30 ).
The thickness of the membrane in the membrane área 575 may be increased.
Laterally inwardly of the peripheral portion 62, the thickness of the membrane 60 increases.
Given the thickness of the membrane ( perhaps from the same slide ), the.
The depth of this groove advantageously represents 30 % to 90 % of the total thickness of the membrane.
The thickness of the membrane 352 will vary depending upon the sonolucent material selected.
A composition according to claim 1, wherein the thickness of the membrane wall ranges between 1 to 1000 microns.
The thickness of the membrane determined by SEM is of the order of 650 nm.
The formed wall thickness of the membrane is 0.2 mm.
Thickness of the membrane ( t ), of the order of ten micrometres ;.
Therefore, the thickness of the membrane is preferably 100 µm or less.
Thickness of the membrane may also range, but is preferably between 25 to 10 micrometers.
Advantageously, the total thickness of the membrane is situated between 0.5 mm and 3 mm.
The thickness of the membrane is measured using an " Inspect " scanning electron microscope ( FEI Corporation ).
In an embodiment, the thickness of the membrane can range between 3 to 10 microns.
You'll also be interested in:
Examples of using Membrane
Show more
Check that the membrane is not blocked
The membrane is only permeable to water molecules
Life expectancy of the membrane potentially extended
Examples of using Thickness
Show more
Minimum recommended thickness of zinc vs thickness of steel
Thickness of tanks made with double walls
Reduction of wall thickness and additional protection
