Examples of 'adjusting knob' in a sentence
Meaning of "adjusting knob"
adjusting knob ~ a physical control or mechanism that allows for fine-tuning or modification of settings, typically found on equipment or devices
How to use "adjusting knob" in a sentence
Basic
Advanced
adjusting knob
Tighten the bevel adjusting knob securely.
Adjusting knob to align thickness guide with blade.
Check pile height adjusting knob for.
Detergent adjusting knob turned to closed position.
Set the minutes with the adjusting knob.
Fluid adjusting knob turned in too far.
Set the seconds with the adjusting knob.
Unscrew the adjusting knob on the front and.
Set the hours with the adjusting knob.
An adjusting knob is screwed onto the mounting base.
A toothed wheel controlled by an adjusting knob allows this adjustment.
Adjusting knob for segment control of connected illumination unit.
Wind fluid adjusting knob out or.
Securely tighten the spade side handle adjusting knob.
Then turn the adjusting knob so that the desired.
See also
Set the braking level with the adjusting knob.
Turning an adjusting knob causes turning the counter rings.
You can save energy by turning the adjusting knob.
The adjusting knob is rotatable.
Remove the support of the idle speed adjusting knob.
You can release the adjusting knob while pulling or pushing.
Adjusting knob for setting light intensity of connected illumination unit.
Remove bail handle by removing guard adjusting knob and hex.
Retighten the adjusting knob and release the chain brake.
Set the desired lock status with the adjusting knob.
Loosen the adjusting knob and move the wheel arm up.
To adjust spring tension under seat turn adjusting knob on front of seat.
There is an adjusting knob attached to the other end of the stem.
It could block the pad holder and jam the adjusting knob.
Tension adjusting knob allows to select the desired level of resistance.
Pluck the back straight edge of blade while turning tension adjusting knob.
Set the depth adjusting knob for the desired depth of cut.
The depth of cut can be adjusted by turning the cutting depth adjusting knob.
An adjusting knob is located on the front of the antenna for antenna gain.
Set the desired gouging current with the remote control adjusting knob.
Turn fluid adjusting knob counter clockwise until first thread shows.
The two limitation sheets delimit the screwing range of the adjusting knob.
The adjusting knob should be turned only within the numbered range.
Set the first program for the program link with the adjusting knob.
Turn the fluid needle adjusting knob counterclockwise to increase fluid flow.
You can adjust the bit height using the micro plunge adjusting knob.
Turn the fluid needle adjusting knob clockwise to decrease fluid flow.
Adjust handle tube in a comfortable position by untighten the adjusting knob at the desired height.
With a special adjusting knob it is possible to adjust the height position precisely.
Replace the bail handle with the bolt and the guard adjusting knob.
Turn the fluid needle adjusting knob counterclockwise until a full coat is obtained.
You control the temperature of the water via the adjusting knob in the heater head.
Loosen the adjusting knob and slide the outer section to the desired setting.
Set the blade guide to the required height by turning the guide post adjusting knob.
After use always turn the adjusting knob anticlockwise and then switch the.
You'll also be interested in:
Examples of using Knob
Show more
Press the volume knob during a call
Each knob is marked with an alchemical symbol
Turn the thermostat knob to a lower number
Examples of using Adjusting
Show more
Adjusting the balance effects all sources
Proceed as for adjusting the left fence
Adjusting the white balance manually recommended
