Examples of 'adjusting screw' in a sentence
Meaning of "adjusting screw"
An adjusting screw refers to a small screw or bolt that is designed to make precise adjustments to the position or alignment of an object. It is often used in machinery or mechanical systems to fine-tune the settings or to make minor changes
How to use "adjusting screw" in a sentence
Basic
Advanced
adjusting screw
Set the adjusting screw at min level.
Loosen hex nut securing adjusting screw.
Loosen the adjusting screw by turning it counter.
Additionally tighten slightly the adjusting screw.
Adjusting screw to the right or left as far as it goes.
Turn material volume adjusting screw to the left.
Adjusting screw right stop position means.
N turn the adjusting screw clockwise.
Adjusting screw for maximum opening of the head.
Tighten the adjusting screw again.
Adjusting screw for oil pump at the bottom.
Adjust pump pressure by turning pressure adjusting screw.
Oil pump adjusting screw incorrectly adjusted.
Chain oil flow adjusting screw.
The adjusting screw is coupled to the nut.
See also
Loosen the lock nut of the adjusting screw.
It has an adjusting screw to operate brass gauge.
Adjusting the idle speed mix adjusting screw.
Adjust the adjusting screw to center the bubble.
Presser foot pressure adjusting screw.
Turn adjusting screw by hand counter.
High speed compression adjusting screw.
Fluid needle adjusting screw not open enough.
The bearing member is an adjusting screw.
Tighten the adjusting screw firmly at the position.
Low speed compression adjusting screw.
Pilot flow adjusting screw beneath cover screw.
Open fluid needle adjusting screw.
Turn pressure adjusting screw counterclockwise to decrease pressure.
Screw to change the movable range of the adjusting screw.
Turn pressure adjusting screw clockwise to increase pressure.
Loosen the lock nut for the adjusting screw.
N turn the adjusting screw counterclockwise.
Now centre the brake arms by turning the adjusting screw.
Adjusting screw of the levelling foot.
Idle air adjusting screw.
Adjusting screw locates at the bottom of the chain saw.
Check to be sure choke adjusting screw is contacting choke control lever.
Adjusting screw for maximum vertical inclination of the head.
Slightly tighten the hoop adjusting screw and pull fabric.
The adjusting screw was locked by a locknut.
Remove the actual knob and regulate the adjusting screw.
The adjusting screw is made of titanium.
Adjust the amount of oil delivery with the adjusting screw.
Safeguard the adjusting screw by fastening the safety nut.
Lock the roller guide in position with the guide adjusting screw.
An adjusting screw or similar must be fitted to prevent axial shifting.
This driver is equipped with an adjuster for adjusting screw driving depth.
Tighten the adjusting screw on the rip fence firmly.
The tension can be adjusted with the locking lever adjusting screw.
You'll also be interested in:
Examples of using Adjusting
Show more
Adjusting the balance effects all sources
Proceed as for adjusting the left fence
Adjusting the white balance manually recommended
Examples of using Screw
Show more
Tighten the screw through the clips
Screw the two sections of pole together
Remove the screw on the rear coupler
