Examples of 'loosen the lock' in a sentence
Meaning of "loosen the lock"
loosen the lock - To make a lock less secure or to unlock it. This phrase is typically used when referring to physically opening a lock by altering its mechanism
How to use "loosen the lock" in a sentence
Basic
Advanced
loosen the lock
Loosen the lock screw of the air shutter.
It might be necessary to loosen the lock.
Loosen the lock nut of the adjusting screw.
A lock pick is a tool used to break or loosen the lock.
Loosen the lock nuts on the feet by hand.
Use the special wrench provided to loosen the lock nut.
Loosen the lock nut on the cable adjuster.
Hold firmly a spanner on the blade flange loosen the lock nut with another spanner.
Loosen the lock lever by raising it.
Push the shaft lock and loosen the lock nut using the lock nut wrench.
Loosen the lock nut with the wrench provided.
A Do not use a tool to loosen the lock nuts to avoid damaging them.
Loosen the lock nut for the adjusting screw.
Turn the LOCK counter clockwise to loosen the lock of the HORIZONTAL adjuster.
Loosen the lock screw for the focus ring.
See also
To remove the depth of cut limit, loosen the lock.
Loosen the lock nut and adjust by screwing in or out.
To adjust, use the supplied wrench to loosen the lock nuts.
Loosen the lock knobs to make large direction changes.
Using the special wrench, loosen the lock nut on each caster.
Loosen the lock knob and lift the router again.
To remove the punch and die, loosen the lock nut with the wrench.
Loosen the lock nut to lower the front of the deck.
A warning, Do not use any tools to loosen the lock nuts.
Loosen the lock screw on the air shutter located at the rear of.
A Do not use any tools to loosen the lock nuts . Otherwise, they will get damaged.
Loosen the lock knobs and see that the table is resting.
Adjusting, - Loosen the lock lever.
Loosen the lock ring and remove the pH sensor from the flow cell.
If adjustment is required, proceed as follows, - Loosen the lock nut ( g ) a few turns.
Loosen the lock knobs and see that the table is resting on the stop bolt.
Spray pattern shape ( see Figure 4 ) - loosen the lock ring and.
Loosen the lock nuts under each back plate and slide the gibs out.
To do this, Loosen the lock screw of the head and rotate the head 180.
Loosen the Lock Ring and take the unit off backward.
Loosen the lock nut . Loosen up the lock nut and give me the Allen wrench.
Loosen the lock screw for the second speed fig . A.
Loosen the lock screw with a 5 mm wrench.
Loosen the lock nut ( a ) with a large wrench b.
To loosen the lock of the drill chuck, turn the rear sleeve toward the “ ” direction.
Loosen the lock screws on the undersides of the carriages see Fig . 7.
Loosen the lock nut and turn the adjustment bolt counterclockwise Figure 43.
Loosen the lock lever, tilt the blade and secure it at 45.
Loosen the lock nut ( 5 ) at the lower end of the cable.
Loosen the lock nut ( 14 ) on the cutter holder and insert a cutter.
Loosen the lock nut ( 53 ) a few turns and turn the bevel position.
Loosen the lock lever ( 13 ), turn the aggregate to the desired angle and lock it again.
Loosen the lock lever counterclockwise and turn the handwheel until the desired angle ( 0 - 45 ) is obtained.
