Examples of 'loosen screws' in a sentence
Meaning of "loosen screws"
loosen screws: to turn screws counterclockwise in order to release or weaken their grip, often done when assembling, disassembling, or adjusting mechanical or electronic devices
How to use "loosen screws" in a sentence
Basic
Advanced
loosen screws
Loosen screws for fastening the appliance.
The unit is intended to drive in and loosen screws.
Loosen screws and remove enclosure lid.
Using this drill with loosen screws is extremely dangerous.
Loosen screws located on top of the fireplace.
Using this impact wrench with loosen screws is extremely dangerous.
Loosen screws and remove junction box.
Hot air may be used to help loosen screws that have been overtightened.
Loosen screws to adjust blower left to right.
Screws too tight Loosen screws.
Loosen screws fixing the support arm.
Using this Heat Gun with loosen screws is extremely dangerous.
Loosen screws on the rod extensions.
Please use the bit reception to loosen screws in anti-clockwise operation.
Loosen screws three to four turns.
See also
If this is not applied exactly at the saw blade, loosen screws securing the.
Loosen screws on back of drawer front brackets as shown.
These have special built-in gears that let you tighten and loosen screws much faster.
Loosen screws on the nose plate.
Aligning the knee lever - Loosen screws 4 and.
Loosen screws in terminal block to remove wires as required.
For prospective adjustments loosen screws ( 1 ) and move the electrodes assembly 2.
Loosen screws holding the top pivot pins.
If necessary, loosen screws holding the top pivot pins.
Loosen screws slightly and adjust.
Note, Tighten or loosen screws with a Phillips screwdriver or the assembly tool.
Loosen screws of the upper vacuum tube by turning counterclockwise.
X To remove, loosen screws and take off trim ;.
Loosen screws holding grille and remove the grille.
For this last check, loosen screws ( 1 ) before removing the right side panel.
Loosen screws and remove clamp from unit to detach.
If necessary, loosen screws that fasten dishwasher to countertop and shift tub.
Loosen screws on the crown and pull out all rods.
Tighten and loosen screws in conjunction with a conventional chuck ( 11 ) and suitable bits and bit holders.
Loosen screws and slide lower hinge right to lower doors.
NOTE, Loosen screws three to four turns.
Loosen screws and slide lower hinge left to raise doors.
Loosen screws on cable clamp and separate cable from disposer.
Loosen screws used to hold the middle hinge and remove middle hinge.
Loosen screws holding thermostat to the wall and lift away the thermostat.
Loosen screws ( G ) holding pump lever bracket just enough so it can be moved.
Loosen screws item 21, pull out centering cover item 7 and inner motor parts.
Loosen screws ( A ) on both sides.
You'll also be interested in:
Examples of using Screws
Show more
The screws are provided in the literature pack
Fully tighten screws with hex wrench
Screws are visible on the burner control panel
Examples of using Loosen
Show more
Loosen the screw at the rod extensions
Use a screwdriver to loosen the air shutter
Loosen the lower pin with a key
