Examples of 'tighten the lock' in a sentence
Meaning of "tighten the lock"
tighten the lock ~ to secure or strengthen the security of a lock or close something securely
How to use "tighten the lock" in a sentence
Basic
Advanced
tighten the lock
Tighten the lock lever firmly as shown.
Be sure to securely tighten the lock nut.
Tighten the lock nut on each caster.
Securely tighten the lock knob.
Tighten the lock nut finger tight.
After adjustment be sure to tighten the lock nut.
Then tighten the lock nut in place.
Adjust the angle and tighten the lock ring.
Tighten the lock nut after the adjustment.
Place the calibrator and tighten the lock screw.
Hand tighten the lock ring after adjustment.
Reinstall the belt guard and tighten the lock handles.
Then tighten the lock handle.
Pivot handle up or down to desired position and tighten the lock.
Finger tighten the lock nuts.
See also
Hold the stop screw in place and tighten the lock nut.
Then tighten the lock screws.
Torque is determined by using a conventional torque wrench to tighten the lock nut.
Tighten the lock lever of the rip fence.
Set the miter gauge to desired angle and tighten the lock knob.
Tighten the lock nut again.
Install the pH sensor in the flow cell and tighten the lock ring.
Tighten the lock nut securely with supplied wrench.
Insert the camera and tighten the lock ring as shown in the image below.
Tighten the lock lever to lock the tool body.
Rotate the control rod to lengthen the rod and tighten the lock nuts.
Tighten the lock nut to secure the die holder.
Set the hex nut to the desired position and tighten the lock lever.
Tighten the lock nut by using the assembly tool.
Check the free play of the clutch lever and tighten the lock nut.
Tighten the lock knob to lock the tool body.
Press the shaft lock and tighten the lock nut using the lock nut wrench.
Tighten the lock nuts and check the alignment.
After adjustment is complete tighten the lock base and install the latch back into place.
Tighten the lock nut against the bottom of the pedestal.
After adjustment, tighten the lock nuts securely.
Tighten the lock nut to secure the die holder in the.
After adjustment, tighten the lock nut securely.
Tighten the lock nuts and check the clearance again.
After adjusting the clearance, tighten the lock nut.
Then tighten the lock lever to secure the fence.
Use two 8 mm wrenches to tighten the lock nut and union nut.
Always tighten the lock knob securely in place before use.
After setting the desired cutting depth, tighten the lock knob.
Do not tighten the lock lever without the shaft of the.
Attach the camera, adjust the angle and tighten the lock.
Do not forget to tighten the lock nut after completing adjustment.
Using the closed end of the assembly tool, tighten the lock nut.
Then tighten the lock lever up to secure the angle guide.
There is no need to excessively tighten the lock nut, just tight is sufficient.
You'll also be interested in:
Examples of using Lock
Show more
Get this lock off the gate
Lock bowl onto base by turning clockwise
Document digital lock concerns and complaints
Examples of using Tighten
Show more
Tighten the screw through the clips
I will just tighten these up for you
Tighten properly the connection block screws
