Examples of 'tighten the nut' in a sentence
Meaning of "tighten the nut"
tighten the nut", "definition": "To use force or a tool to secure or fasten a nut in place.
How to use "tighten the nut" in a sentence
Basic
Advanced
tighten the nut
Do not tighten the nut at this time.
Do not use a wrench to tighten the nut.
Tighten the nut on the cable support.
A tool is required to tighten the nut on the collet.
Tighten the nut as shown in the diagram.
Once this is achieved tighten the nut securely.
Then tighten the nut one additional turn.
Hold the adjusting flats and tighten the nut.
Tighten the nut and locknut on the transmission.
Replace the outlet tube and tighten the nut.
Tighten the nut with a wrench.
A tool is required to tighten the nut on the rotor and collet.
Tighten the nut properly as described in this manual.
Use the wrench to tighten the nut securely with clockwise.
Tighten the nut on the plug to prevent disconnection.
See also
Use the included wrench to tighten the nut turning it anticlockwise.
Tighten the nut firmly with wrench provided.
Use other appropriate methods and tools to tighten the nut.
Finger tighten the nut only at this time.
You can use a standard crescent wrench to tighten the nut.
Then tighten the nut firmly.
Replace the pressure relief tube and tighten the nut.
Then tighten the nut one more full.
Put the bit back in place and tighten the nut.
Securely tighten the nut q so that the cotton stand does.
Replace the sprocket cover and tighten the nut gently.
Tighten the nut on the draw bar with a wrench.
A spanner or similar tool may be used to tighten the nut securely.
Tighten the nut when fitting the new blade.
Slide the tube onto the nipple and tighten the nut.
Manually tighten the nut against the isolator screw.
Slide the nut and ferrule forward and finger tighten the nut.
Securely tighten the nut with the wrench provided.
Thread cable and nut into the adapter plate and tighten the nut.
Tighten the nut to secure the faucet to the sink.
Insert a new clamping collet with nut into the spindle and slightly tighten the nut.
Tighten the nut without moving the riving knife.
Place the nut and ferrule on the tubing and tighten the nut until water tight.
Tighten the nut down onto the bracket tab.
After adjustment is completed, securely tighten the nut u.
Tighten the nut by turning against the direction of rotation.
Place the screw, tighten the nut and tighten.
Tighten the nut again using the mounting tool.
If the brush head rattles during use, tighten the nut further.
Then tighten the nut on the bottom of the cooler.
If the brush head rattles when in use, tighten the nut further.
Then tighten the nut and the screw again.
While holding the locking rod in place, tighten the nut by turning it counterclockwise.
Tighten the nut against the tube at end of cable.
If water passes rapidly into the lower container, tighten the nut further.
You'll also be interested in:
Examples of using Nut
Show more
I am kind of a hard nut to crack in that department
A nut who knows a lot about bombs
Loosen the bottom nut to eliminate water
Examples of using Tighten
Show more
Tighten the screw through the clips
I will just tighten these up for you
Tighten properly the connection block screws
