Examples of 'tighten the hex' in a sentence
Meaning of "tighten the hex"
tighten the hex: To secure or fasten a hexagonal-shaped nut or bolt by turning it to the right until it is firmly in place. This term is commonly used in mechanical or engineering contexts where hex nuts and bolts are used
How to use "tighten the hex" in a sentence
Basic
Advanced
tighten the hex
Be sure to tighten the hex nut securely.
Pivot the trap slightly above horizontal and tighten the hex bolt securely.
Be sure to tighten the hex bolt securely.
Place the ground lug on the screw and tighten the hex nut securely.
Securely tighten the hex cap screws.
Use the hex . socket wrench to tighten the hex.
Then tighten the hex bolts securely.
Return to the lower handle and tighten the hex bolt securely.
Then tighten the hex screws definitively.
Press the spindle lock until it engages and tighten the hex head bolt clockwise.
Tighten the hex nut securely.
Then fully tighten the hex nut.
Tighten the hex knob screw.
Do not over tighten the hex head screw.
Tighten the hex socket screws.
See also
After adjusting the angle, tighten the hex bolts securely.
Tighten the hex nut to secure the chain.
Using a hex key, tighten the hex set screw securely.
Tighten the hex nuts finally.
While holding the wire in place, tighten the hex nut securely.
Loosely tighten the hex nuts for further adjustment.
While holding the mounting bracket in place, securely tighten the hex nut.
Be sure to tighten the hex socket head bolt securely.
After attaching the protector and the protector holder, tighten the hex bolts securely.
Tighten the hex bolt to the torque listed below.
While holding the wire in place, tighten the hex nut you loosened securely.
Tighten the hex rod until the spring on the.
After obtaining the desired position, tighten the hex nuts to secure the hex bolts.
Tighten the hex bolts to secure the gauge plate.
After adjusting the hanger position, tighten the hex bolt with the wrench securely.
Always tighten the hex bolt securely after changing.
Warning, Do not over tighten the hex head bolt.
Then tighten the hex bolts to secure the stay.
When you have reach about 28 turns it is time to tighten the hex drive studs.
Securely tighten the hex screw and coved spacer.
Adjust the spreader accordingly and tighten the hex bolts ( A ) securely.
Tighten the hex nut against the main shaft.
After adjustment, securely tighten the hex bolt and then the clamping nut clockwise.
Tighten the hex bolt to secure the angle head.
After adjusting the tension, tighten the hex bolt firmly to secure the chain bar.
Tighten the hex nuts on the front track idler wheels.
To increase the preload, tighten the hex nut clockwise in ¼ turn intervals.
Tighten the hex nut in the direction of arrow as shown in the figure.
To lower the foot further, tighten the hex nut clockwise with a 12 mm wrench.
Tighten the hex nut just enough to hold tray center in place.
Then tighten the hex bolt clockwise to secure the center cover.
Adjust the riving knife accordingly and tighten the hex bolts ( A ) securely.
Tighten the hex nut against the main shaft without stripping it.
Impeller housing and also tighten the hex nuts that secure hopper bracket to hopper assembly.
