Examples of 'loosen the bolt' in a sentence
Meaning of "loosen the bolt"
loosen the bolt - This phrase instructs to make a fastener or screw less tight, usually using tools or by hand
How to use "loosen the bolt" in a sentence
Basic
Advanced
loosen the bolt
Loosen the bolt on the handle just enough.
Use the second wrench to loosen the bolt at the bottom.
Loosen the bolt on the bottom of the tool.
First, use the hex wrench to loosen the bolt.
Loosen the bolt on the magazine.
To reposition the shoe, loosen the bolt with hex wrench.
Loosen the bolt counterclockwise with the wrench.
To install the saw blade, loosen the bolt by hex wrench.
Slowly loosen the bolt using a ring spanner.
When the switch is set to L, the motor rotates counterclockwise to loosen the bolt.
Loosen the bolt with the hex wrench provided.
To install the blade, loosen the bolt with the hex wrench.
Loosen the bolt by turning counterclockwise do not remove nuts.
To change the magazine, loosen the bolt and remove the magazine.
Loosen the bolt using an appropriate tool screw driver.
See also
If it runs to the opposite side, loosen the bolt slightly half turn of bolt.
Loosen the bolt and separate left and right sections.
To change the hanger position, loosen the bolt on the hanger . Then move the hanger.
Loosen the bolt that connects the lower shaft to the coil.
Throttle Distance Adjustment Loosen the bolt with a 2.5mm hex wrench.
Loosen the bolt until the bolt collar is free of the blade.
To adjust, loosen the bolt and remove the caster.
Loosen the bolt on the back of the base with the hex wrench.
To install it, loosen the bolt on the front of the base.
Loosen the bolt that holds the negative terminal and remove the negative cable first.
To install the blade, loosen the bolt on the blade clamp with the hex wrench.
Loosen the bolt on the handle just enough to move it Fig.
To install the blade, loosen the bolt on the blade holder with the hex wrench.
Loosen the bolt y, and then move the needle bar w.
With the hex wrench, loosen the bolt which holds the base and retainer.
Loosen the bolt q, and then remove the treadle support w and the square nut e.
Dismounting - Loosen the bolt and take away the washer.
Loosen the bolt counterclockwise on the blade holder with the allen wrench see Figure 1.
Do not loosen the bolt excessively, otherwise the basket may fall suddenly.
Loosen the bolt ( A ) to adjust to the desired height, firmly tighten the bolt after adjustment.
Loosen the bolt ① and the remove the muffler cap ②, the muffler screen ③ and spark arrester ④.
Fully loosen the bolt ( A ) on the right side of the bracket ( B ) to slide the shield.
You'll also be interested in:
Examples of using Bolt
Show more
Remove the bolt with a socket wrench
Bolt or clamp the saw to its support
Stiffener bracket bolt must be kept tightened
Examples of using Loosen
Show more
Loosen the screw at the rod extensions
Use a screwdriver to loosen the air shutter
Loosen the lower pin with a key
