Examples of 'hex nuts' in a sentence
Meaning of "hex nuts"
hex nuts - nuts with a six-sided shape used to fasten bolts in mechanical and construction settings
How to use "hex nuts" in a sentence
Basic
Advanced
hex nuts
Tighten hex nuts and replace covers.
Tighten the two hex nuts.
Replace hex nuts and tighten securely.
Retighten the four hex nuts.
Washers and hex nuts on the bolts.
Hex nuts attached to terminal block.
Washers and hex nuts not included.
Hex nuts are used everywhere else.
Remove the two hex nuts including washers.
Tighten the four hex nuts.
Today hex nuts have displaced them.
Secure them with the washers and hex nuts.
Then readjust the hex nuts at the handle.
The hex nuts should be tightened against each other.
Tighten the hex nuts finally.
See also
Maintain eccentric shaft position and tighten hex nuts.
Loosely tighten the hex nuts for further adjustment.
Remove the chipper chute by removing three hex nuts and.
Tighten the hex nuts on the front track idler wheels.
Secure using the two bolts and hex nuts previously removed.
Hex nuts on feet should be recessed into hexagonal sockets in side rails.
Place a washer and two hex nuts on each cable end.
Your super rings just look like rocks glued to hex nuts.
Tighten the six hex nuts that secure hopper assembly to.
Attach handle bracket with two cap screws and two hex nuts.
Remove the carriage bolts and hex nuts which attach it to.
Remove the two hex nuts on top of the heater securing it to the heater.
Now you can remove the two bottom hex nuts including washers.
Remove the two hex nuts holding the light reflector in place.
Use the four short hex head bolts and four hex nuts to secure.
Loosen the six hex nuts securing the skid shoes to the housing.
Fully Tighten the hex carriage bolts and hex nuts.
Loosen the two locking hex nuts that secure the tracking screws.
After wires have been placed on terminals, attach with hex nuts provided.
Loosen the hex nuts securing the top of the heater to the heater support.
Assemble fan on motor shaft and tighten hex nuts firmly be careful not to overtighten.
Remove the hex nuts from the lower panel on each side at the rear.
Remove the thermal cut-off switch assembly by removing the two hex nuts.
Use the four hex nuts to secure the hex bolts to the unit housing.
After obtaining the desired position, tighten the hex nuts to secure the hex bolts.
Tighten the two hex nuts securing the top of the heater to the heater support.
It would probably be the nuts. The hex nuts.
Install the lock washers and hex nuts from the underside of the workbench.
IMPORTANT, Verify the tightness of the hex nuts.
Loosen the two hex nuts in the container intended for fixing the stone bracket.
Fasten six sets of bolts, lockwashers, flat washers, and hex nuts previously.
Remove the carriage bolts and hex nuts which attach it to the snow thrower housing.
The impeller is secured to the impeller shaft with two ( 2 ) shear bolts and hex nuts.
Impeller housing and also tighten the hex nuts that secure hopper bracket to hopper assembly.
Attach the handle using two 13mm wrenches with two capscrews and two hex nuts.
